Shoprider START 8 GK9 User Manual download pdf (Page 8)

7/8/2009SE

Seat Height Adjustment (Fig 5)

Remove seat as described (fig 4). Remove battery

pack (refer to disassembly section). Using two

13mm wrenches, remove locking bolt and nut.

Adjust seat post up or down to desired position.

The seat height can be adjusted to five different

positions by inserting the locking bolt in the

desired hole. Replace washer and nut and tighten.

Replace battery pack and seat.

Serial Number (Fig 5)

Serial number is located on the seat post. It is on a white

sticker with a barcode. The serial number is 13

alphanumerical digits beginning with the number 1.

Armrest Width Adjustments (Fig 6)

On the underside back of the seat there are two

arm rest hand knobs, one on each side. Turn

hand knobs counterclockwise to loosen.

Loosening the arm rest hand knob allows the

armrest width to be adjusted or arm rest to

be removed. Once the desired positions of

the arm rests are set, tighten the hand knobs

by turning clockwise to lock the arm rests into place.

Armrest Adjustments (Fig 6)

The arm rests may be pulled up and out of the

way for sideways transfer. Pull arm rest up and back.

The arm rest angle may be adjusted by turning the adjustment screw either clockwise or

counterclockwise depending on the desired angle.

Figure 5

Scooter

Serial

Number

Locking

Bolt

Seat

Post

Adjustment

Holes

Figure 6

Armrest

tightening knob

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

No comments

Shoprider START 8 GK9 User Manual Page 8